Intel 10/100 Manual De Usuario
61
Console Command Reference
C H A P T E R
3
get-stp
get-stp
Displays the current state of spanning tree (either enabled or
disabled). By default, spanning tree is enabled in accordance with
802.1d.
disabled). By default, spanning tree is enabled in accordance with
802.1d.
SYS_console> get-stp
Running Spanning Tree engine is enabled
Next session the Spanning Tree engine will be enabled
set-stp
set-stp {enable|disable}
Enables or disables the spanning tree protocol. Enabled is the default.
Enabling or disabling spanning tree doesn’t take effect until the
SNMP agent is reset (
Enabling or disabling spanning tree doesn’t take effect until the
SNMP agent is reset (
warm-reset
,
cold-reset
, or turning the power
off and then on again).
get-st-bcfg
get-st-bcfg
Displays the spanning tree bridge parameters. If spanning tree is
disabled, parameters aren’t displayed.
disabled, parameters aren’t displayed.
SYS_console> get-st-bcfg
802.1D SPANNING TREE BRIDGE INFO
==================================
Designated Root : 8000-0020-1a00-0a5b
Bridge Priority : 32768
Root Cost : 0
Root Port : 0
Max Age : 20
Hello Time : 2
Hold Time : 1
Forward Delay : 15
Bridge Max Age : 20
Bridge Hello Time : 2
Bridge Forward Delay : 15