Cisco Systems 3560 Manual De Usuario

Reconnect the power cord to the switch and, within 15 seconds, press the Mode button while the System 
LED is still flashing green. Continue pressing the Mode button until the System LED turns briefly amber 
and then solid green; then release the Mode button. 

Several lines of information about the software appear with instructions, informing you if the password 
recovery procedure has been disabled or not. 

If you see a message that begins with this:

The system has been interrupted prior to initializing the flash file system. The 

following commands will initialize the flash file system

go to the 

, and follow the steps.

If you see a message that begins with this:

The password-recovery mechanism has been triggered, but is currently disabled. 

go to the 

, and follow the steps.

After recovering the password, reload the switch:

Switch> reload

Proceed with reload? [confirm] y

If the password-recovery mechanism is enabled, this message appears:

The system has been interrupted prior to initializing the flash file system. The following 

commands will initialize the flash file system, and finish loading the operating system 

software:

flash_init

load_helper

boot

Initialize the flash file system:

switch: flash_init

If you had set the console port speed to anything other than 9600, it has been reset to that particular 
speed. Change the emulation software line speed to match that of the switch console port.

Load any helper files:

switch: load_helper

Display the contents of flash memory:

switch: dir flash:

The switch file system appears:

Directory of flash:

   13  drwx         192   Mar 01 1993 22:30:48  c3560-ipservices-mz-122-25.SEB

   11  -rwx        5825   Mar 01 1993 22:31:59  config.text

   18  -rwx         720   Mar 01 1993 02:21:30  vlan.dat

16128000 bytes total (10003456 bytes free)