Cisco Systems 3560 Manual De Usuario
21-20
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 21 Configuring DHCP Features and IP Source Guard
Configuring DHCP Server Port-Based Address Allocation
Port-Based Address Allocation Configuration Guidelines
These are the configuration guidelines for DHCP port-based address allocation:
•
Only one IP address can be assigned per port.
•
Reserved addresses (preassigned) cannot be cleared by using the clear ip dhcp binding global
configuration command.
configuration command.
•
Preassigned addresses are automatically excluded from normal dynamic IP address assignment.
Preassigned addresses cannot be used in host pools, but there can be multiple preassigned addresses
per DHCP address pool.
Preassigned addresses cannot be used in host pools, but there can be multiple preassigned addresses
per DHCP address pool.
Enabling DHCP Server Port-Based Address Allocation
Beginning in privileged EXEC mode, follow these steps to globally enable port-based address allocation
and to automatically generate a subscriber identifier on an interface.
and to automatically generate a subscriber identifier on an interface.
After enabling DHCP port-based address allocation on the switch, use the ip dhcp pool global
configuration command to preassign IP addresses and to associate them to clients.
configuration command to preassign IP addresses and to associate them to clients.
Beginning in privileged EXEC mode follow these steps to preassign an IP address and to associate it to
a client identified by the interface name.
a client identified by the interface name.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
ip dhcp use subscriber-id client-id
Configure the DHCP server to globally use the
subscriber identifier as the client identifier on all
incoming DHCP messages.
subscriber identifier as the client identifier on all
incoming DHCP messages.
Step 3
ip dhcp subscriber-id interface-name
Automatically generate a subscriber identifier based
on the short name of the interface.
on the short name of the interface.
A subscriber identifier configured on a specific
interface takes precedence over this command.
interface takes precedence over this command.
Step 4
interface interface-id
Specify the interface to be configured, and enter
interface configuration mode.
interface configuration mode.
Step 5
ip dhcp server use subscriber-id client-id
Configure the DHCP server to use the subscriber
identifier as the client identifier on all incoming
DHCP messages on the interface.
identifier as the client identifier on all incoming
DHCP messages on the interface.
Step 6
end
Return to privileged EXEC mode.
Step 7
show running config
Verify your entries.
Step 8
copy running-config startup-config
(Optional) Save your entries in the configuration file.