Cisco Systems 3560 Manual De Usuario

To turn off the RIP routing process, use the no router rip global configuration command.

To display the parameters and current state of the active routing protocol process, use the show ip 
protocols privileged EXEC command. Use the show ip rip database privileged EXEC command to 
display summary address entries in the RIP database.

RIP Version 1 does not support authentication. If you are sending and receiving RIP Version 2 packets, 
you can enable RIP authentication on an interface. The key chain specifies \the set of keys that can be 
used on the interface. If a key chain is not configured, no authentication is performed, not even the 
default. Therefore, you must also perform the tasks in the 

The switch supports two modes of authentication on interfaces for which RIP authentication is enabled: 
plain text and MD5. The default is plain text.

Beginning in privileged EXEC mode, follow these steps to configure RIP authentication on an interface:

version {1 | 2}

(Optional) Configure the switch to receive and send only RIP Version 1 
or RIP Version 2 packets. By default, the switch receives Version 1 and 2 
but sends only Version 1. 

 

You can also use the interface commands ip rip {send | receive} version 
1 | 2 | 1 2} to control what versions are used for sending and receiving on 
interfaces. 

(Optional) Disable automatic summarization. By default, the switch 
summarizes subprefixes when crossing classful network boundaries. 
Disable summarization (RIP Version 2 only) to advertise subnet and host 
routing information to classful network boundaries.

(Optional) Disable validation of the source IP address of incoming RIP 
routing updates. By default, the switch validates the source IP address of 
incoming RIP routing updates and discards the update if the source 
address is not valid. Under normal circumstances, disabling this feature 
is not recommended. However, if you have a router that is off-network 
and you want to receive its updates, you can use this command.

output-delay delay

(Optional) Add interpacket delay for RIP updates sent.

 

By default, packets in a multiple-packet RIP update have no delay added 
between packets. If you are sending packets to a lower-speed device, you 
can add an interpacket delay in the range of 8 to 50 milliseconds. 

end 

Return to privileged EXEC mode.

Verify your entries.

(Optional) Save your entries in the configuration file.

Enter global configuration mode.

interface interface-id

Enter interface configuration mode, and specify the 
interface to configure.