Compaq 2724 Manual De Usuario

5-11

Compaq Netelligent 2724/2824 Dual-Speed Hub User Guide

Writer:  Chris Seiter Project: Compaq Netelligent 2724/2824 Dual-Speed Hub User Guide  Comments:

ile Name:2824_5.DOC Last Saved On:06/25/97 5:32 PM

Traps

To receive a trap, the SNMP network management station must place its IP or
IPX address into the appropriate trap destination table of the Netelligent Unified
MIB (CPQNUNIF). The trap destination tables are listed below:

■

 

For IP traps, the destination table is cpqnIpTrapDestTable

■

 

For IPX traps, the destination table is cpqnIpxTrapDestTable

Each IP and IPX trap tables can contain a maximum of ten entries.

The table below summarizes the traps generated by the hub. The headings are
defined as follows: MIB is the MIB or RFC that defines the traps. Trap lists the
traps by a convenient name. RFC1157 Trap Type lists the RFC1157 generic trap
category to which the trap belongs; for enterpriseSpecific traps, the enterprise
and trap numbers are also shown. Variable Bindings lists the additional MIB
objects included in the trap message.

Generated Traps

MIB

Trap

RFC1157 Trap Type

Variable Bindings

RFC1157

Cold Start

coldStart(1)

(none)

Authentication
Failure

authenticationFailure(4)

(none)

RFC1757
(RMON)

Rising Alarm

enterpriseSpecific(6): rmon.1

alarmIndex, alarmVariable, alarmSampleType,
alarmValue, alarmRisingThreshold

Falling Alarm

enterpriseSpecific(6): rmon.2

alarmIndex, alarmVariable, alarmSampleType,
alarmValue, alarmFallingThreshold

RFC1516** Health

enterpriseSpecific(6):
snmpDot3RptrMgt.1

rptrOperStatus, rptrHealthText

Group Change enterpriseSpecific(6):

snmpDot3RptrMgt.2

rptrGroupIndex

Reset

enterpriseSpecific(6):
snmpDot3RptrMgt.3

rptrOperStatus