Billion Electric Company BiGuard 10 Manual De Usuario

 

 

118

- Make sure each Ethernet cable connection is secure at the firewall and at the hub 
or workstation. 
- Make sure that power is turned on to the connected hub or workstation. 
- Be sure you are using the correct cable. When connecting the firewall’s Internet 
port to a cable or DSL modem, use the cable that was supplied with the cable or DSL 
modem. This cable could be a standard straight-through Ethernet cable or an 
Ethernet crossover cable. 

 

 
Try entering the default User Name and Password: 
 
User Name: admin 
Password: admin 
 
Please note that both the User Name and Password are case-sensitive. 
 
If this fails, you can restore your BiGuard 2/10 to its factory default settings by 
holding the Reset button on the back of your router until the Status LED begins to 
blink. Then enter the default User Name and Password to access your router. 

 

 

Refer to this section for issues relating to BiGuard 2/10’s LAN Interface. 

 
5.2.1    Can’t Access BiGuard 2/10 from the LAN 
 

If there is no response from BiGuard 2/10 from the LAN: 
 
- Check your Ethernet cable types and each connection. 
- Make sure the computer’s Ethernet adapter is installed and functioning properly. 
 
If the error persists, you may have a hardware problem, and should contact 
technical support. 

 
5.2.2    Can’t Ping Any PC on the LAN 

 
If PCs connected to the LAN cannot be pinged: