Gateway 6400 Manual De Usuario
40
Replacing and Adding System Components
Replacing or adding a processor
The system is compatible with the Pentium
®
III (FC-PGA Socket 370) 667 MHz
and faster processors with 133 MHz front-side bus (FSB). As many as two
processors may be installed in the system (they must have the same processor
and FSB speed). Processor and FSB speed are automatically detected by the
system, therefore there are no system board jumpers to set.
processors may be installed in the system (they must have the same processor
and FSB speed). Processor and FSB speed are automatically detected by the
system, therefore there are no system board jumpers to set.
When adding or replacing a processor, order a processor upgrade kit from
Gateway. The kit includes the processor, a heatsink, and a disposable,
antistatic wriststrap. The kit also contains a copy of the muloader.exe
program, which must be run to update the microcode table and enable the
second processor. Voltage Regulator Modules (VRMs) for both processors are
built into the system board.
Gateway. The kit includes the processor, a heatsink, and a disposable,
antistatic wriststrap. The kit also contains a copy of the muloader.exe
program, which must be run to update the microcode table and enable the
second processor. Voltage Regulator Modules (VRMs) for both processors are
built into the system board.
To replace the processor you must perform the following tasks:
■
Remove the heatsink
■
Remove the processor
■
Install the new processor
■
Replace the heatsink
To remove the heatsink:
1
Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
installed), and all external peripheral devices.
2
Remove the left side cover panel. (See “Removing the side cover” on
page 18 and “Preventing static electricity discharge” on page 15.)
page 18 and “Preventing static electricity discharge” on page 15.)
3
Disconnect the fan cable from the fan connector on the system board.
(See “System board” on page 6 for the location of the fan connector.)
(See “System board” on page 6 for the location of the fan connector.)
Caution
A heatsink must be installed on each processor. Installing
a processor without a heatsink could result in damage to,
or failure of, the processor.
a processor without a heatsink could result in damage to,
or failure of, the processor.
05032.book Page 40 Monday, July 10, 2000 11:43 AM