Gateway 6400 Manual De Usuario
Replacing the power supply
55
Replacing the power supply
To remove the power supply:
1
Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
installed), and all external peripheral devices.
2
Remove the left side cover panel. (See “Removing the side cover” on
page 18 and “Preventing static electricity discharge” on page 15.)
page 18 and “Preventing static electricity discharge” on page 15.)
3
Lay the case on its right side, if possible.
4
Disconnect the power supply connectors from all internal devices
including the 3.5-inch diskette drive, the CD drive, and all hard drives.
including the 3.5-inch diskette drive, the CD drive, and all hard drives.
5
Disconnect the main power supply connector to the system board by
pressing on the tab to release the connector, then gently pulling the
connector from the board.
pressing on the tab to release the connector, then gently pulling the
connector from the board.
6
Remove the cable supports securing the power supply cables to the
chassis.
chassis.
05032.book Page 55 Monday, July 10, 2000 11:43 AM