Gateway 7450R Manual De Usuario

Replacing and Adding Internal Devices          

If necessary, set any jumpers on the CD drive assembly. (See your drive 
documentation for proper drive jumper settings and cable orientation.)

Place the CD drive assembly in the chassis. Make sure the hooks extend 
through the slots on the bracket, then slide the CD drive assembly 
forward.

Secure the CD drive assembly with the two screws you removed in Step 4.

Connect the power and data cables, making sure the cables are in the 
correct position and orientation.

The IDE cable ships with the CD drive kit. Make sure you route the cable 
directly from the CD drive, through the cable clamp, and to the primary 
IDE connector on the system board. Other routing may interfere with 
internal airflow and the thermal characteristics of the server.

Close the case. See “Closing the case” on page 20.

Reconnect the power cord and all other external peripheral devices, then 
turn on the system.

The CD drive assembly is located beside the diskette drive assembly in the 
center of the front panel.

Turn off the system and disconnect the power cord and all other external 
peripheral devices.

Open the case. See “Opening the case” on page 18 and “Preventing static 
electricity discharge” on page 17.

Remove the power and data cables from the small printed circuit board 
at the back of the drive. Note their locations and orientations.

The replacement drive should include the bracket and 
small circuit board. If it does not, transfer those 
components to the new drive.

8507328.book  Page 25  Thursday, February 15, 2001  11:28 AM