Gateway 7210 Manual De Usuario

Starting the server          

Place the tabs on the outriggers into the corresponding slots on the 
bottom panel and slide the outriggers toward the ends of the chassis.

Carefully return the chassis to the upright position.

Before you start the server for the first time:

■

The redundant power supply is autosensing. It automatically determines 
the voltage of the incoming power source and compensates accordingly. 
The optional PS/2 power supply has a voltage selector switch. Make sure 
that the voltage selector switch on the PS/2 power supply is set to the 
correct voltage for your area.

■

Make sure all cables are firmly connected to the proper ports on the back 
panel of the computer.

■

Make sure that both power supply modules in the redundant power 
supply are turned on. (The PS/2 power supply does not need to be turned 
on separately.)

■

Make sure the computer and monitor are plugged into an AC outlet, 
power strip, or UPS and that the power strip or UPS is turned on.

If you have connected the system components to a power strip or UPS, 
make sure all the system components are turned off, then turn on the 
power strip or UPS.

Turn on the monitor.

Turn on the computer. Make sure the individual power buttons on the 
power supply modules are turned on. The light-emitting diodes (LED) in 
the power button and on each power supply module are on when the 
power is on.

Electricity can flow from connected peripherals into the 
system causing a shock. Make sure the server and 
peripherals are turned off and unplugged from the power 
outlet when you connect peripherals to the computer.

8505945.book  Page 17  Thursday, March 9, 2000  2:13 PM