Axis Communications Network Print Servers Manual De Usuario

AXIS 5500 / AXIS 5550 User’s Manual

123

To further increase security, you must disable protocols that are 

considered insecure; 

•

FTP (also used by AXIS ThinWizard, if FTP is disabled, AXIS ThinWizard 
can not function properly.)

•

Telnet

•

Auto-IP

•

DHCP

•

BOOTP

•

Remote Config (used by AXIS NetPilot)

•

SNMP Configuration (also used by AXIS ThinWizard. Note that if SNMP 
is disabled, AXIS ThinWizard can not function properly.)

To disable these protocols, go to Admin | Security Settings | Protocol 

Settings | Detailed View and mark the check boxes. Click OK to finish. 

To enable these protocols, select Admin | Network Settings | Detailed 

View | TCP/IP Network for FTP, Telnet, Auto-IP, DHCP and BOOTP. 

Remote Config is enabled via Admin | General Settings | RConfig 

Support.

To check SSL/TLS status, open the print server’s Web interface and select 

Admin | Network Settings | Detailed View | TCP/IP Network to see if 

the HTTPS Enabled parameter is set to Yes or No.

To view a Certificate, open the print server’s Web interface, select Admin 

| Security Settings and click View next to the Certificate.

To delete a Certificate, open the print server’s Web interface, select Admin 

| Security Settings and click Delete next to the Certificate.

Some USB printers do not deliver correct port status to the print server 

(for instance always reporting printer off-line even if the printer is on-

line). If you set the Override Portstatus parameter to Yes, the print server 

will ignore the port status. To set this parameter, select Admin | General 

Settings | USB1 from the print server’s Web interface.

To ensure maximum security, it is highly recommended that you change your Administrator 

password after generating a certificate and disabling insecure protocols! This is done from