Cisco Systems 3.3 Manual De Usuario

To assign a particular command authorization set that affects device-management 
application actions on any network device, follow these steps:

Select the Assign a device-management application for any network device 
option.

Then, from the list directly below that option, select the command 
authorization set you want applied to this user.

To create associations that assign a particular command authorization set that 
affects device-management application actions on a particular NDG, for each 
association, follow these steps:

Select the Assign a device-management application on a per Network Device 
Group Basis option.

Select a Device Group and an associated device-management application.

Click Add Association.

The associated NDG and command authorization set appear in the table.

Do one of the following:

If you are finished configuring the user account options, click Submit to 
record the options.

To continue to specify the user account options, perform other procedures in 
this chapter, as applicable.

If you want TACACS+ AAA clients to permit unknown services, you can select 
the Default (Undefined) Services check box under Checking this option will 
PERMIT all UNKNOWN Services.

To configure the Unknown Service setting for a user, follow these steps:

Perform Step 1 through Step 3 of 

The User Setup Edit page opens. The username being added or edited is at the top 
of the page.

Scroll down to the table under the heading Checking this option will PERMIT all 
UNKNOWN Services.