Datalogic Scanning 1000I Manual De Usuario

Getting Started

1-2

Magellan

1000i

Connecting the Scanner

The scanner kit you ordered to match your interface should provide a compatible cable for your
installation. Use the appropriate instructions below to connect the scanner to the terminal, PC
or other host device.

Upon completing the connection via the appropriate interface instructions below, proceed to
the

Interface Related Features

section of this manual and scan the barcode to select the correct

interface type.

RS-232 Serial Connection —

Turn off power to the terminal/PC and connect the scanner

to the terminal/PC serial port via the RS-232 cable as shown in

Figure 1

. If the terminal will not

support POT (Power Off the Terminal) to supply scanner power, use the approved power supply
(AC Adapter). Plug the AC Adapter barrel connector into the socket on the RS-232 cable con-
nector and the AC Adapter plug into a standard power outlet.

Figure 1

. RS-232 Serial or USB Connection using A/C Adapter

USB Connection —

Connect the scanner to a USB port on the terminal/PC using the correct

USB cable for the interface type you ordered. Reference

Figure 1

and

Figure 2

Figure 2. Other Connection Types

NOTE

USB installations may require a power connection via
an approved A/C Adapter as shown in

Figure 1

. For

example, this would be the case if the scanner is con-
nected along with a number of other devices to a non-
powered USB hub.

I/F Cable

Connect
Here

A/C Adapter
(if needed)

For 220-230 VAC
adapters, the
cord must be
facing down as
shown in the
illustration. If
installed upwards,
it will pose an
undue strain on the
socket outlet.

To Host/Terminal

U S

oar

or...