Brocade Communications Systems DCX 8510-4 Manual De Usuario

WWN card removal and replacement

5

FIGURE 26

Removal and replacement of the blower assembly

‘

Replacing a blower assembly

Complete the following steps to replace the blower assembly in a chassis.

1. Orient the blower assembly and slide it into the chassis, pushing firmly to ensure that it is 

seated.

2. Verify that the power LED displays a green light.

3. Use the screwdriver or your fingers to tighten the captive screws.

WWN card removal and replacement

Use this procedure to remove and replace a WWN card.

NOTE
The World Wide Name (WWN) cards contain fully redundant circuits and normally do not require 
replacement. Two WWN cards are located beneath the WWN bezel (logo plate).