Brocade Communications Systems 53-1002599-01 Manual De Usuario
Brocade ICX 6650 Hardware Installation Guide
21
53-1002599-01
Assigning permanent passwords
3
Setting passwords
1. At the opening CLI prompt, enter the following command to change to the Privileged level of the
EXEC mode:
Brocade> enable
2. Access the CONFIG level of the CLI by entering the following command:
Brocade# configure terminal
Brocade(config)#
3. Enter the following command to set the super user password:
Brocade(config)# enable super-user-password text
NOTE
You must set the super user password before you can set other types of passwords.
4. Enter the following commands to set the port configuration and read-only passwords:
Brocade(config)# enable port-config-password text
Brocade(config)# enable read-only-password text
NOTE
Syntax: enable super-user-password | read-only-password | port-config-password text
Passwords can be up to 32 characters long.
Recovering from a lost password
By default, the CLI does not require passwords. However, if someone has configured a password for
the device but the password has been lost, you can regain super user access to the device using
the following procedure.
the device but the password has been lost, you can regain super user access to the device using
the following procedure.
NOTE
Recovery from a lost password requires direct access to the serial port and a system reset.
Use the following procedure to recover from a lost password.
1. Start a CLI session over the serial interface to the Brocade device.
2. Reboot the device.
3. While the system is booting, before the initial system prompt appears, enter b to enter the boot
monitor mode.
4. Enter no password at the prompt. (You cannot abbreviate this command.)
After the console prompt reappears, assign a new password.