Graco 3A1324B Manual De Usuario
Install the Kit
6
3A1324B
Power Connection
Enclose all cables routed in the spray booth and high
traffic areas in conduit to prevent damage from paint,
solvent, and traffic.
traffic areas in conduit to prevent damage from paint,
solvent, and traffic.
The ProMix 2KE operates with 85-250 VAC, 50/60 Hz
input power, with a maximum of 2 amp current draw.
The power supply circuit must be protected with a 15
amp maximum circuit breaker.
input power, with a maximum of 2 amp current draw.
The power supply circuit must be protected with a 15
amp maximum circuit breaker.
Not included with kit:
•
Power supply cord compatible to your local power
configuration. Wire gauge size must be 8-14 AWG.
configuration. Wire gauge size must be 8-14 AWG.
•
The input power access port is 22.4 mm (0.88 in.) in
diameter. It accepts a bulkhead strain relief fitting or
conduit.
diameter. It accepts a bulkhead strain relief fitting or
conduit.
1.
Verify that electrical power at the main panel is shut
off.
off.
2.
Connect electrical cord to the terminal block (404)
as shown in F
as shown in F
. 5.
3.
Close the Control Box. Restore power.
4.
Follow instructions in Grounding in your ProMix
2KE Operation Manual.
2KE Operation Manual.
5.
See your ProMix 2KE Operation manual for operat-
ing instructions.
ing instructions.
All electrical wiring must be completed by a qualified
electrician and comply with all local codes and
regulations.
electrician and comply with all local codes and
regulations.
F
IG
. 5. Terminal Block Electrical Connections
F
IG
. 6. Electrical Schematic
ti16391a
Ground
Neutral
Line
411
404
LINE POWER
FILTER
POWER
SUPPLY
TERMINAL
BLOCK
SWITCH
ROCKER
1A
1
2A
2
L N GRND
L N GRND
L N
GRND
WIRE
HARNESS
(411)
WIRE
HARNESS
(410)
POWER SUPPLY
WIRE HARNESS
WIRE HARNESS