Cisco Systems 3750E Manual De Usuario

Descargar
Página de 1236
 
29-3
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-02
Chapter 29      Configuring UDLD
Configuring UDLD
Event-driven detection and echoing
UDLD relies on echoing as its detection mechanism. Whenever a UDLD device learns about a new 
neighbor or receives a resynchronization request from an out-of-sync neighbor, it restarts the 
detection window on its side of the connection and sends echo messages in reply. Because this 
behavior is the same on all UDLD neighbors, the sender of the echoes expects to receive an echo in 
reply.
If the detection window ends and no valid reply message is received, the link might shut down, 
depending on the UDLD mode. When UDLD is in normal mode, the link might be considered 
undetermined and might not be shut down. When UDLD is in aggressive mode, the link is 
considered unidirectional, and the port is disabled. 
If UDLD in normal mode is in the advertisement or in the detection phase and all the neighbor cache 
entries are aged out, UDLD restarts the link-up sequence to resynchronize with any potentially 
out-of-sync neighbors.
If you enable aggressive mode when all the neighbors of a port have aged out either in the advertisement 
or in the detection phase, UDLD restarts the link-up sequence to resynchronize with any potentially 
out-of-sync neighbor. UDLD shuts down the port if, after the fast train of messages, the link state is still 
undetermined. 
 shows an example of a unidirectional link condition.
Figure 29-1
UDLD Detection of a Unidirectional Link
Configuring UDLD
These sections contain this configuration information:
TX
TX
RX
RX
Switch A
Switch B
Switch B successfully
receives traffic from
Switch A on this port.
98648
However, Switch A does not receive traffic
from Switch B on the same port. If UDLD
is in aggressive mode, it detects the 
problem and disables the port. If UDLD is 
in normal mode, the logical link is 
considered undetermined, and UDLD 
does not disable the interface.