Cisco Systems ASR 901 10G Manual De Usuario

3-19

Cisco ASR 901 10G Series Aggregation Services Router Hardware Installation Guide

OL-28105-02

Chapter 3 Installing the Cisco ASR 901 10G Router

Installing and Removing SFP Modules

Removing SFP Modules

Complete the following steps to remove an SFP module from a module receptacle:

Step 1

Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.

Step 2

Disconnect the cable from the SFP module, and insert a dust plug into the cable end.

Tip

For reattachment, note which cable connector plug is transmit (TX) and which is receive (RX).

Step 3

Unlock and remove the SFP module, as shown in

Figure 3-20

If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp
latch is obstructed and you cannot use your index finger to open it, use a small, flat-blade screwdriver
or other long, narrow instrument to open the bale-clasp latch.

Figure 3-20

Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver

Step 4

Grasp the SFP module between your thumb and index finger, and carefully remove it from the
module slot.

Step 5

For fiber-optic SFP modules, insert a dust plug into the optical ports of the SFP module to keep the
optical interfaces clean.

Step 6

Place the removed SFP module in an antistatic bag or any other protective casing.

4577

Bale Clasp

—