Graco 289650 Manual De Usuario
312932A
Instructions
Pump Kit for
X5, X7, LTS 15 and LTS 17 Airless Sprayers
X5, X7, LTS 15 and LTS 17 Airless Sprayers
This manual contains kit installation instructions only
Pump Replacement Kit: 289650
Pressure Relief Procedure
Important Safety Instructions
For detailed sprayer information and warnings, see Operation manuals
312001 or 313034 included with Magnum sprayers.
312001 or 313034 included with Magnum sprayers.
To help prevent injection injuries, follow this
procedure when you stop spraying and
before you service or clean the sprayer,
remove parts, or repair leaks.
procedure when you stop spraying and
before you service or clean the sprayer,
remove parts, or repair leaks.
1.
Turn power switch OFF. Unplug sprayer.
2.
Turn Spray/Prime valve to PRIME to relieve pressure. Turn
pressure control knob left (counterclockwise) to minimize
pressure.
pressure control knob left (counterclockwise) to minimize
pressure.
3.
Trigger gun.
4.
Put trigger safety in safety ON position.
NOTE: Leave Spray/Prime valve in the PRIME
position until you are ready to spray again.
position until you are ready to spray again.
If you suspect that the spray tip or hose is completely clogged
or that pressure has not been fully relieved after following the
steps above, VERY SLOWLY loosen the tip guard retaining nut
or hose end coupling to relieve pressure gradually. Then
loosen it completely. Clear the tip or hose obstruction.
or that pressure has not been fully relieved after following the
steps above, VERY SLOWLY loosen the tip guard retaining nut
or hose end coupling to relieve pressure gradually. Then
loosen it completely. Clear the tip or hose obstruction.
ti11868a
ti11858a