Bakers Pride CSWG Manual De Usuario

1.  Now, attach the End Trim Panels to the base ends. The studs on the Trim Panels pass through 

the mounting holes in the base ends (see Figure 2). Both End Trim Panels are the same.  
 

2.  The panels are secured from inside with the #10 Pal Nuts provided. 

 

3.  Attach the End Panels to the ends of the case(s) as shown in Figure 2 using the shoulder screws 

provided. For Glass End Panels only, slide the plastic bushings provided over the shoulder 
screws before inserting the screw into the glass panel. Be careful that the screws do not bind in 
the holes in the glass panel.  
 
NOTE: If the ends are already attached to the case, the End Kick Plates can be lowered to the 
floor. To do this loosen the End Trim Panel nuts from inside the case then slide the Kick Plates 
flush with the floor and tighten the Trim Panel nuts. 
 

4.  These cases are to be sealed to the floor if required by local health codes. Seal the kick plates to 

the floor using a silicone-type sealant (Dow Corning RTV #732 or equivalent). 

 

 

Figure 2.  Floor Model - End Kick Plate & End Panel Mounting