Bakers Pride CSWG Manual De Usuario

1.  After leveling the cases and bolting the bases together, bolt the canopies together as shown in 

Fig. 6 with a ¼”-20 x ¾” Hex Head Screw and Keps Nut.  
 

2.  Mount the Upper Front & Base Front Joint Trims by holding them in place and marking the hole 

locations on the case.  
 

3.  Make certain the joint covers are centered on the joint and that they align vertically with each 

other.  
 

4.  Drill the case holes 5/32” and attach joint covers with screws provided.  Before tightening the top 

screws of the Upper Front Trim, slide the Counter Front Trim in place between the screw head 
and the Upper Front Trim. 

 
5.  Attach Bumper Ends and Bumper Mounting  Base to the front of the cases, centered on the 

vertical surface of the upper front of the case.  Cut the Bumper Top to length to fit between the 
Bumper Ends and snap into place. 

 
 

Figure 6. Joining WDCTY Cases