Emerson I-0021 Manual De Usuario

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98

NGA 2000

↓↓

Analyzer module setup

↓↓

Measurement display configuration

↓↓

In the menu "Measurement Display Configuration" you can determine

♦ 

the parameters for the single component display for one channel of an MLT analyzer or
analyzer module. To set up the conditions of the other channels, you have to press the
F3 key.

♦ 

the display of the confirmation menus.

♦ 

the tags of the MLT analyzer or analyzer module and the tags of each range for the
current channel (2nd page of the menu).
Caution:
If you change the identification tag, you have to change the configuration of the
programmable digital inputs and analog outputs. Because, the parameters of the
module source will change! So, the relations will disappear !

Set up parameters:

♦ 

Select any line of variables with the 

↓↓

 -key or the 

↑↑

 -key.

♦ 

Select the variable with the 

88 

 -key or the 

→

→

 -key.

♦ 

Adjust a new value with the 

↑↑

 -key or the 

↓↓

 -key

resp. select the whole parameter with the 

↑↑

 -key or the 

↓↓

 -key.

♦ 

Confirm the new value with the 

88 

 -key or

cancel and go back to the last value with the F2 key.

Measure

Channel

Back...

Tags...

TAG

95.00 ppm

-- Measurement Display Configuration (1/2) --

Displayed concentration digits:

4

Display confirmation menus:

Yes

Signal on mini-bargraph - 1:

Temperature

Signal on mini-bargraph - 2:

Maintenance-Requests

Signal on mini-bargraph - 4:

Operation

Digits after decimal point:

2

Signal on mini-bargraph - 3:

Any_Alarms