Emerson I-0021 Manual De Usuario

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98

NGA 2000

Press the 

88 

 -key or the 

→

→

 -key in the line "Configuration of Relay Outputs..." of the menu

"Local SIO Configuration Parameters" to change to the corresponding menu:

In the menu "Relay Outputs" you can attach signals to the relay outputs of the local SIO
board, e.g the relation between the zero valve and a certain channel. You have to put a
number code (= variable of a signal) in the corresponding line for the relay:

There are three relays on the local SIO board. With a jumper you can determine the relay
contact status: NO or NC. Informations about the whole specification of the SIO board you
can find in another manual.

Note:
In this menu you only can determine the relay output configuration for channels of the
analyzer module, not for channels of auxiliary modules.

Set up parameters:

♦ 

Select any line of variables with the 

↓↓

 -key or the 

↑↑

 -key.

♦ 

Select the variable with the 

88 

 -key or the 

→

→

 -key.

♦ 

Select the code number for the signal with the 

↑↑

 -key or the 

↓↓

 -key.

+

+

♦ 

Confirm the new value with the 

88 

 -key or

cancel and go back to the last value with the F2 key.

Lines of variables "Relay 1, 2, 3 - actual state":

These lines display the current gear status of each relay. The lines are not available.

Measure

Back...

TAG

95.00 ppm

-- Relay Outputs --

Relay 1 - output signal:

4

Relay 3 - output signal:

6

Relay 2 - actual state:

Off

Relay 3 - actual state:

Off

Relay 2 - output signal:

5

Relay 1 - actual state:

On