KitchenAid 2316571A Manual De Usuario

Descargar
Página de 64
6
Normal Sounds
Your new refrigerator may make sounds that your old one didn’t 
make. Because the sounds are new to you, you might be 
concerned about them. Most of the new sounds are normal. Hard 
surfaces, such as the floor, walls, and cabinets, can make the 
sounds seem louder. The following describes the kinds of sounds 
and what may be making them.
If your refrigerator is equipped with an ice maker, you will hear 
a buzzing sound when the water valve opens to fill the ice 
maker for each cycle.
Your refrigerator is designed to run more efficiently to keep 
your food items at the desired temperatures and to minimize 
energy usage. The high efficiency compressor and fans may 
cause your refrigerator to run longer than your old one. You 
may also hear a pulsating or high-pitched sound from the 
compressor or fans adjusting to optimize performance.
You may hear the evaporator fan motor circulating air through 
the refrigerator and freezer compartments. The fan speed 
may increase as you open the doors or add warm food.
Rattling noises may come from the flow of refrigerant, the 
water line, or items stored on top of the refrigerator.
Water dripping on the defrost heater during a defrost cycle 
may cause a sizzling sound.
As each cycle ends, you may hear a gurgling sound due to 
the refrigerant flowing in your refrigerator.
Contraction and expansion of the inside walls may cause a 
popping noise.
You may hear air being forced over the condenser by the 
condenser fan.
You may hear water running into the drain pan during the 
defrost cycle.
Ensuring Proper Air Circulation
In order to ensure proper temperatures, you need to permit 
airflow between the two sections. Cold air enters the bottom of 
the freezer section and moves up. It then enters the refrigerator 
section through the top vent. Air then returns to the freezer as 
shown. 
Do not block any of these vents with food such as soda, cereal, 
bread, etc. Do not block any airflow vents. If the vents are 
blocked, airflow will be obstructed and temperature and moisture 
problems may occur.
IMPORTANT: Because air circulates between both sections, any 
odors formed in one section will transfer to the other. You must 
thoroughly clean both sections to eliminate odors. To avoid odor 
transfer and drying out of food, wrap or cover foods tightly.
Using Controls
IMPORTANT: 
The refrigerator control adjusts the refrigerator compartment 
temperature. The freezer control adjusts the freezer 
compartment temperature.
Wait 24 hours after you turn on the refrigerator before you put 
food into it. If you add food before the refrigerator has cooled 
completely, your food may spoil. 
NOTE: Adjusting the refrigerator and freezer controls to a 
lower (colder) setting will not cool the compartments any 
faster.
If the temperature is too warm or too cold in the refrigerator or 
freezer, first check the air vents to be sure they are not 
blocked before adjusting the controls.
The preset settings should be correct for normal household 
usage. The controls are set correctly when milk or juice is as 
cold as you like and when ice cream is firm.
The actual temperature may differ from the display when a 
door is open for an extended period of time.
NOTE: The factory recommended set points are 0°F (-18°C) for 
the freezer and 37°F (3°C) for the refrigerator.
Turning Refrigerator On and Viewing Set Points
Press the Cooling (ON/OFF) touch pad. 
NOTE: 
After the refrigerator is turned on, the Over Temperature audio 
alarm and indicator light may activate every 1
¹⁄₂ hours until 
the refrigerator and freezer temperatures are below 48°F (9°C) 
and 15°F (-9°C), respectively, or until the alarm is turned off. 
To turn off the audio alarm and indicator light, see “Master 
Alarm Reset.”
The ON/OFF touch pad on the control panel shuts down 
refrigerator functions such as cooling, lighting, fans and 
compressors. To turn the power off completely, use the 
power ON/OFF switch located behind the top grille. See 
“Power On/Off Switch.”
Viewing the Celsius Temperatures
Press °C touch pad. To redisplay degrees Fahrenheit, press 
°C again. 
NOTE: If the freezer temperature is below zero, the negative sign 
next to the freezer display will light up. This is normal.