Garmin Flight Deck 100 Manual De Usuario
190-00728-04 Rev. A
Embraer Prodigy
®
Flight Deck 100 Pilot’s Guide
151
AUDIO PANEL AND CNS
GTX 33/33D TRANSPONDER CONTROLS
Transponder function is displayed on three levels of softkeys on the PFD: Top-level, Mode Selection, and
Code Selection. When the top-level XPDR Softkey is selected, the Mode Selection softkeys appear: XPDR1,
XPDR2, STBY, ON, ALT, GND, VFR, CODE, IDENT, BACK.
XPDR2, STBY, ON, ALT, GND, VFR, CODE, IDENT, BACK.
When the CODE Softkey is selected, the number softkeys appear: 0, 1, 2, 3, 4, 5, 6, 7, IDENT, BKSP,
BACK. The digits 8 and 9 are not used for code entry. Selecting the numbered softkeys in sequence enters
the transponder code. If an error is made, selecting the BKSP Softkey moves the code selection cursor to the
previous digit. Selecting the BKSP Softkey again moves the cursor to the next previous digit.
the transponder code. If an error is made, selecting the BKSP Softkey moves the code selection cursor to the
previous digit. Selecting the BKSP Softkey again moves the cursor to the next previous digit.
Selecting the BACK Softkey during code selection reverts to the Mode Selection Softkeys. Selecting the BACK
Softkey during mode selection reverts to the top-level softkeys.
The code can also be entered with the FMS Knob on either PFD. Code entry must be completed with either
the softkeys or the FMS Knob, but not a combination of both.
Selecting the IDENT Softkey while in Mode or Code Selection initiates the ident function and reverts to the
top-level softkeys.
After 45 seconds of transponder control inactivity, the system reverts back to the top-level softkeys.
Figure 4-34 Transponder Softkeys (PFD)
Selecting the
BACK Softkey
returns to the top-level softkeys.
Selecting the
BACK Softkey returns to the mode selection softkeys.
MSG
MSG
BACK
BKSP
IDENT
7
6
5
4
3
2
1
0
STBY
ON
ALT
VFR
CODE
IDENT
BACK
XPDR
GND
IDENT
XPDR1
XPDR2
Selecting and activating Transponder 1 or Transponder 2:
1)
Select the XPDR Softkey to display the Transponder Mode Selection Softkeys.
2)
Select the XPDR1 or XPDR2 Softkey to select and activate the other transponder.
When turning on the system for use, the system defaults to the transponder active prior to shutdown. When
switching between Transponder 1 and Transponder 2, the code and mode remain the same. If a new code is
entered in the active transponder, switching transponders does not bring back the previous code.
entered in the active transponder, switching transponders does not bring back the previous code.