Garmin 190-01166-02 Manual De Usuario

Detach this checklist from the installation instructions and use it to assist with the GHC 10 installation process.
Read all installation instructions before installing the GHC 10. Contact Garmin Product Support if you have any questions during the 

installation process.

  1.  Refer to the charts on 

pages 9–18

 for the proper locations of the pump, the Shadow Drive, and other hydraulic 

requirements. Verify that the hydraulic steering layout of the boat supports the GHP 10 autopilot system.

  2. Refer to the diagram and notes on 

  3. Lay out all of the components, and check the cable lengths. Obtain extensions if necessary.
  4.  Mount the pump by following the directions starting on 

 The pump must be located within 19

1

/

2

 in. (0.5 m) of  

the ECU.

  5.  Install the pump in the hydraulic steering system by following the directions starting on 

. Do not bleed the 

  6.  Mount the ECU by following the directions starting on 

page 25. 

The pump must be located within 19

1

/

2

 in. (0.5 m) of  

the ECU. Connect the pump to the ECU.

  7.  Mount the CCU by following the directions starting on 

. Mount the CCU in a location free of magnetic 

interference. Use a handheld compass to test for magnetic interference in the area. Mount the CCU in the bracket so 

that the wires hang straight down.

  8.  Install the Shadow Drive by following the directions starting on 

. Do not bleed the hydraulic steering system at 

  9.  Wire the CCU to the tachometer of the boat by following the directions starting on 

  10.  Mount the GHC 10 by following the directions starting on 

  11.  Connect the GHC 10 and the CCU to a NMEA 2000 network. Connect an optional NMEA 2000-compatible GPS device 

to the NMEA 2000 network (

  12.  Wire the yellow wire on the GHC 10 data cable to the yellow CCU signal wire on the CCU/ECU interconnect cable and 

the black wire on the GHC 10 data cable to CCU ground. Wire an optional NMEA 0183-compatible GPS device to the 

GHC 10 if a NMEA 2000-compatible GPS device is not available (

).

  13. Complete the final battery connections by following the directions on 

  14.  Bleed the hydraulic steering system. Consult the manufacturer of your steering system for bleeding instructions. 

thoroughly check for leaks in the hydraulic steering system (

 

15.  Apply a corrosion blocker to all of the installed components except the GHC 10. (Bo-Shield or Corrosion X,  

for example)

  16. Configure the GHP 10 system by completing the Dockside Wizard and the Sea Trial Wizard (

  17. Re-examine the hydraulic steering system for leaks and for proper hydraulic fluid levels.