Aussie 69F6U00KS1 Manual De Usuario

5. Use a pipe cleaner to clear insect nests from the inlet hole of Burner (Fig. 15)

6. Open up the Burner holes (Fig. 15) with a small nail or wire. Use a non-metal-

lic brush to remove food particles and corrosion from the Burner surfaces.

7. Check the Electrode mounting on each burner to see if it is loose. If so, tighten the screw holding the Electrode to

maintain 3/16” gap between Electrode tip and burner.

NOTE: Before next step, you may wish to clean the rest of the grill. See Grill Body and Cart (p. 19).

8. After cleaning, refit the burners.

NOTE:

When refitting the burners, be sure each burner is positioned correctly. The valves should protrude inside the

Venturi ends of the burner. (Figs. 12 & 14) Replace the screws that fasten the burner flange to back wall.

9. If the grill is to be stored, wrap burners in a protective cover, such as aluminum foil, to keep insects out.

10. Check burner operation after re-assembly.

11. Replace Flavor Activators and Cooking Grids.

Fig. 15

Non-metallic

Brush

Pipe Cleaner

Open up

Burner holes

with a small

nail or wire.

Fig. 16

3/16” gap

Electrode

Wire

Burner

Make sure the screw holding the

electrode is tight so 3/16”gap

between electrode tip and burner

is maintained. If necessary, gently

bend the electrode wire so there is a

3/16” gap between the wire end and

the burner

Bottom Body Panel Removal

The Bottom Body Panel may be removed for cleaning. First remove the Grease Pan containing the Foil Pan. Next
remove the crossbrace at the bottom back of the firebox. Remove the one screw at each end and slide the Bottom Body
Panel out the back of the firebox.