GTO R4854 01 Manual De Usuario

  GTO 4000XLS Instruction Manual © 01.10.12

Position the operator rear mount between post pivot bracket. 

Place a 

1

/

2

” bushing above the rear mount and a 

3

/

16

”  bushing 

under the rear mount. Align the hole in rear mount, bushings 

and post pivot bracket and secure with the 3 

1

/

2

” clevis pin 

and hair pin clip.

Place a 

3

/

16

” bushing under the front mount and attach the 

gate bracket to the front mount using the 1 

3

/

4

” clevis pin and 

hairpin clip.

Open the gate to the desired open position. Position the 

operator so that the gate bracket rests against the gate along 

the level scribed line. Check the clearance between the 

operator and the gate. The operator should only make contact 

with the gate at the gate bracket. There should be a minimum 

clearance of 2” between the widest part of the operator arm 

and the gate. 
When you have achieved the best position for the post pivot 

bracket in the open position, insert the 

3

/

8

” x 3 

3

/

4

” bolt and 

3

/

8

” flat washer through the aligned holes of the post bracket

and post pivot bracket to hold it in place.
Clamp the gate bracket to the gate using c-clamps or another 

type of clamp.
IMPORTANT: While determining the position of the post 

pivot bracket, be sure that the position allows for minimum 

2“ of clearance between the gate and the operator in both 

the open and closed positions. This clearance will give the 

operator the most efficient leverage point for opening and 

closing the gate and, more importantly, provides the least 

possible pinch area.

Operator

3/8” x 3-1/2” Clevis Pin

3/8” x 1/2” Delrin Bushing

3/8” x 3/16” Delrin Bushing

under rear mount

Hairpin Clip

3/8” x 1-3/4” Clevis Pin

Hairpin Clip

Gate Bracket

Front Mount

3/8” x 3/16” Delrin Bushing

under front mount

Clamp

Pinch Area