Cisco Systems 2960 Manual De Usuario
7-19
Catalyst 2960 and 2960-S Switch Software Configuration Guide
OL-8603-09
Chapter 7 Managing Switch Stacks
Configuring the Switch Stack
This example shows how to configure the persistent MAC address feature for a 7-minute time delay and
to verify the configuration:
to verify the configuration:
Switch(config)# stack-mac persistent timer 7
WARNING: The stack continues to use the base MAC of the old Master
WARNING: as the stack MAC after a master switchover until the MAC
WARNING: persistency timer expires. During this time the Network
WARNING: Administrators must make sure that the old stack-mac does
WARNING: not appear elsewhere in this network domain. If it does,
WARNING: user traffic may be blackholed.
Switch(config)# end
Switch# show switch
Switch/Stack Mac Address : 0016.4727.a900
Mac persistency wait time: 7 mins
H/W Current
Switch# Role Mac Address Priority Version State
----------------------------------------------------------
*1 Master 0016.4727.a900 1 0 Ready
Assigning Stack Member Information
•
(optional)
•
(optional)
•
(optional)
Assigning a Member Number
Note
This task is available only from the master.
Beginning in privileged EXEC mode, follow these steps to assign a member number to a member. This
procedure is optional.
procedure is optional.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
switch current-stack-member-number
renumber new-stack-member-number
renumber new-stack-member-number
Specify the current member number and the new member number for the
member. The range is 1 to 4.
member. The range is 1 to 4.
You can display the current member number by using the show switch
user EXEC command.
user EXEC command.
Step 3
end
Return to privileged EXEC mode.
Step 4
reload slot stack-member-number
Reset the stack member.
Step 5
show switch
Verify the stack member number.
Step 6
copy running-config startup-config
Save your entries in the configuration file.