Smeg DO10PSS Manual De Usuario
Instructions for the installer
51
For operation on 400-415 V 2N
∼
: use an H05RR-F / H05RN-F type four-
core cable (4 x 1.5 mm
2
).
For operation on 230-240 V
∼
: use an H05RR-F / H05RN-F type three-
core cable (3 x 4 mm
2
).
The cable end to be connected to the appliance must be provided with an
earth wire (yellow-green) at least 20 mm longer.
The manufacturer declines all responsibility for damage to persons or things caused by non-
observance of the above guidelines or by interference with any part of the appliance.
15.4 Installing the oven
The oven is designed for installing into any piece of furniture as long as heat-resistant. Follow the
dimensions given in Figure 1-2 allowing for a clearance of 80 to 90 mm at the top of the column.
Tighten the four screws A inside the frame to secure (Fig. 1).
dimensions given in Figure 1-2 allowing for a clearance of 80 to 90 mm at the top of the column.
Tighten the four screws A inside the frame to secure (Fig. 1).
(1)
(2)
The vent B shown in the diagram ensures the air flow required for the oven cooling fans.
Never use the oven door to lever the oven into place when fitting.
Avoid exerting too much pressure on the oven door when open.