Indesit IS50E1X Guía Del Usuario
GB
3
TABLE OF CHARACTERISTSICS
Dimensions
Oven HxDxW
Oven HxDxW
34x39x44
Volume
58 l
Useful
measurements
relating to the oven
compartment
measurements
relating to the oven
compartment
width 42 cm
depth 44 cm
height 18 cm
depth 44 cm
height 18 cm
Voltage and
frequency
frequency
see data plate
Electric Hob
Rapid Ø 180 mm: 2000 W
Rapid Ø 145 mm: 1500 W
Max. Hob Power Absorption: 7000 W
ENERGY LABEL
Directive 2002/40/EC on the label of
electric ovens.
Standard EN 50304
Energy consumption for Natural
convection – heating mode: Static
mode;
electric ovens.
Standard EN 50304
Energy consumption for Natural
convection – heating mode: Static
mode;
This appliance conforms to the following
European Economic Community
directives: 2006/95/EC dated 12/12/06
(Low Voltage) and subsequent
amendments - 04/108/EC dated
15/12/04 (Electromagnetic
Compatibility) and subsequent
amendments - 93/68/EEC dated
22/07/93 and subsequent amendments.
European Economic Community
directives: 2006/95/EC dated 12/12/06
(Low Voltage) and subsequent
amendments - 04/108/EC dated
15/12/04 (Electromagnetic
Compatibility) and subsequent
amendments - 93/68/EEC dated
22/07/93 and subsequent amendments.
2002/96/EEC
1275/2008 (Stand-by/ Off mode)
1275/2008 (Stand-by/ Off mode)
V
Fig. A
Fig. B
Connecting the supply cable to the mains
WARNINGS: THIS APPLIANCE MUST BE
EARTHED.
Important:
WARNINGS: THIS APPLIANCE MUST BE
EARTHED.
Important:
The cooker must be connected to the
mains by a switched (double pole) cooker outlet
correctly fused with a capacity appropriate to that shown
on the cooker Rating Plate. All electrical wiring from
the consumer unit to the cooker, via the switched double
pole cooker outlet, must be of an acceptable type and
current rating as above.
Note:
correctly fused with a capacity appropriate to that shown
on the cooker Rating Plate. All electrical wiring from
the consumer unit to the cooker, via the switched double
pole cooker outlet, must be of an acceptable type and
current rating as above.
Note:
the supply cable must be positioned so that it
never reaches at any point a temperature 50°C higher
than the room temperature. The cable must be routed
away from the rear vents.
than the room temperature. The cable must be routed
away from the rear vents.
700 mm
HOT PARTS