Toshiba tdp-wx5400u Guía Del Usuario

58

59

Item p q

Select the 

power on mode. Press   and select the power on mode using p q.

Manual—the projector must be powered on manually using the control panel or remote.
Auto—the projector powers on automatically when the main power switch is turned on.

Sets the time to wait for the power to be turned off after the last operation is made with 
no input signal. Press   and select the lamp interval using p q.

Off/5 min./10 min./20 min./30 min.

Screen trigger Enable or disable the screen trigger function. Press   and select On or Off using p q. 

Select the desired fan mode. Press   and select the fan mode using p q.

Standard/High

Select the image source that the projector will search for automatically on startup. Press   

and select the default input device using p q.
Last source/Auto./Computer1/Computer2/Computer3/Y-PB-PR/Video/S-video

Video: Press   and select the default video mode using p q. 

Auto./NTSC/PAL/SECAM
S-video: Press   and select the default S-video mode using p q.

Auto./NTSC/PAL/SECAM

Enable or disable the onscreen warning and informational messages. Press   and select On 

or Off using p q.

Set the interval between filter cleaning warning messages. Press   and select the desired 

interval using p q.
Off/100H/200H/500H/1000H

Search mode Set the search mode. Press   and select the desired search mode using 

p

 q.

Standard/Fine

If 

[Power on] is set to [Auto] and there is a power outage, the projector will come on 

once power is restored.

Setting 

[Fan mode] to [High] increases the cooling fan speed. (The cooling fan noise 

gets louder.) Set this option to use the projector, for example, at high altitude (over 1,200 

meters above sea level). 

Do not set Fan mode to 

[High] when using the projector at a lower altitude.”



•

•

The 

Status display screen provides a quick access to the detailed information on projector status. 

The 

Status display menu contains four distinct tabs; Usage time, Input, Network, and Version.

Information on the 

Status display screens is read only. 

Item p q

Displays the Lamp1 life remaining as a percentage.

Displays the Lamp2 life remaining as a percentage.

Lamp1 time Displays the Lamp1 total usage in hours.
Lamp2 time Displays the Lamp2 total usage in hours.
PJ time

Displays the projector's total usage in hours.

Displays the filter total usage in hours.

Displays 

[Lamp 1/2 time] as a measure of when the lamp should be replaced. (Cannot be 

used as a counter of guaranteed lamp time.) When the displayed time approaches 2,000 

hours, consult with a dealer about getting replacement for:  

TLPLW25 for TDP-WX5400 (sold separately).

Item p q

Input name Displays the input terminal that is currently being used.
Signal

Displays the signal name of the currently being used.

H-sync. freq. Displays horizontal frequency in KHz
V-sync. freq. Displays vertical frequency in Hz
Video mode Displays video type, if present.
Sync

Displays synchronization type.

Sync polarity Displays sychronization polarity.
Scan type

Displays the scan type.

•



