Toshiba tdp-wx5400u Guía Del Usuario

8

This product incorporates glass 

components, including a lens and 

a lamp.  If such parts should break, 

please handle with care to avoid 

injury and contact your dealer for 

repair service.  The broken pieces 

of glass may cause to injury.  In the 

unlikely event of the lamp rupturing, 

thoroughly clean the area around 

the projector and discard any edible 

items placed in that area.

Do not attempt to service this 

product yourself as opening or 

removing covers may expose you to 

dangerous voltage or other hazards.  

Refer all servicing to qualified service 

personnel.

When replacement parts are 

required, be sure the service 

technician has used replacement 

parts specified by the manufacturer 

or have the same characteristics as 

the original part.

Unauthorized substitutions may 

result in fire, electric shock, or 

other hazards.

Upon completion of any service 

or repairs to this product, ask the 

service technician to perform safety 

checks to determine that the product 

is in proper operating condition.

The heat from the unit could erase 

the information on the thermal 

paper, or cause deformation or 

warping.

Do not place the product in a box 

or in any other closed installation 

state. Otherwise it may overheat. This 

could result in a risk of fire.

If your line voltage is 220 to 240V, use one of the following types of cable/plug.

Plug

configuration Plug type

Australian

240V

10A

North American

240V

15A

Switzerland

240V

6A

Line voltage

EURO

UK

220 – 240V

220 – 240V

200 – 240V

200 – 240V

200 – 240V

Plug

configuration Plug type

Line voltage

Use a 5A fuse which is approved by ASTA 

or BSI to BSI362.

Always replace the fuse cover after 

changing the fuse.

Never operate this unit immediately after moving it from a cold location to a warm location. 

When the unit is exposed to such a change in temperature, moisture may condense on the lens 

and the crucial internal parts. To prevent the unit from possible damage, do not use the unit for 

at least 2 hours when there is an extreme or sudden change in temperature.

Do not place in hot locations, such as near heating equipment.  Doing so could cause 

malfunction, and shorten the life of the projector.

Avoid locations with oil or cigarette smoke.  Doing so will dirty the optical parts, shortening 

their lives, and darkening the screen.

Do not use this product in the upright position or tilt it up or down by more than 20° from 

level. Doing so may cause a failure or shorten the life of the product.

Using this instrument near a TV or radio may cause interference to the images or audio 

sound. If this happens, move it away from the TV or radio.

In a high altitude location where air is thin, cooling efficiency is reduced so use the 
projector with [

Fan mode] set to [High]. 

Only plug the power cord into outlets rated for use with the power cord’s specified voltage 

range. Do not overload extension cords or table taps as this can result in fire or electric 

shock.

Route the power cable or the connecting cable away from where people could trip over it. 

The projector may fall down, which could result in severe injury.

Be sure the power cord is easily reached for unplugging in case of emergency. Do not 

place any obstacles near a wall outlet in which the cord is plugged.

•

•

•

•

•

•

•

•