Mitsubishi 120u Manual De Usuario

- 12 -

Figure 10

(a) Disconnect and connect the USB cable to the up-

stream port of the display monitor.

(b) Power Off/On the display monitor.

If the mark       appears with  “Generic USB HUB”, then
enumeration was unsuccessful.  Select “Generic USB
HUB” marked with      mark and click “Remove” and
“Refresh”.  After that, the enumeration is automatically
started.

The enumeration of USB HUB may be necessary for
each USB   port on the computer.

3.

Enumerate the Mitsubishi Monitor Function using the
following procedure.

(1) Insert Windows

®

 98 CD-ROM into your computer.

Then, Figure 11 will  appear.

Figure 11

Figure 8

1.

Power on the display monitor and computer.

2.

Enumerate Mitsubishi USB HUB using the follow-
ing procedure.

• During the enumeration of Mitsubishi USB Hub, connect

the keyboard and mouse equipped with USB function, to
the computer and not to the downstream ports on the
display monitor.  After the enumeration, the keyboard and
mouse can be used by connecting to the downstream
ports.

• Do not unplug the USB cable during the enumerations.

(1) Connect the computer and the display monitor with the

included USB upstream cable.  Figure 8 will appear.

(2) Click “Next” on Figure 8 to get Figure 9.
(3) Click “Finish” on Figure 9 to complete the enumeration

of Mitsubishi USB HUB.

You can  confirm that “Mitsubishi USB HUB” is successfully
enumerated with the following method.

•

Open “Device Manager” tab in “System” property
under “Control Panel”.  Confirm that  “Generic USB
HUB” is listed in “Universal Serial Bus Controller”.  If
you can’t confirm it, re-enumerate “Mitsubishi USB
HUB” again by following (a) or (b).

Figure 9