Mitsubishi ws-55809 Manual De Propietario

•  The TV remote control does not work. 

•  Check that the batteries are installed correctly.

 

•  Check that the selected switch is set to “TV”.

 

•  Be no further than 20 feet from the TV when using the 

 

   remote control.

•  The TV takes several seconds to respond to 

•  Press ENTER after a channel number to avoid delays.

    channel commands. 

•  Use the three digit number, i.e 002 for channel 2.

•  You cannot access a channel. 

•  Use number keys instead of CHANNEL up/down.

 

•  Be sure the channel you want to view is in memory.

 

•  Check that the TV is turned to the correct input source for 

 

   that channel, by pressing the INPUT button.

 

•  Make sure the V-Chip lock is off (page 42).

•  On-screen displays appear each time you change a function.  •  This is part of normal TV operation.

•  You cannot program the TV to turn on automatically. 

•  The TV may be locked.

 

•  The clock may not be set.

•  There is no sound even when the volume is turned up. 

•  Check to see if the MUTE button is on.

 

•  The TV’s “Listen to:” setting may be set to SAP.

 

•  Check that “TV Speakers” setting is ON.

•  You have forgotten your lock passcode. 

•  See Appendix A, Bypassing the V-Chip Lock, page 63.

•  PIP does not display a picture. 

•  Make sure the V-Chip lock is off (page 42).

 

•  Not all inputs can be displayed as a PIP (page 14).

•  The sound does not match the screen picture. 

•  The TV’s “Listen to:” setting may be set to SAP.

 

•  If using stereo or A/V reveiver speakers, check input selec

 

   tion on the stereo or A/V receiver.

 

•  If using stereo or A/V receiver, check that AUDIO is from 

 

   MONITOR OUTPUT on TV’s back panel.

•  There is a large black or gray rectangle on the screen. 

•  The TV closed captioning has been set to “text” mode, but 

 

  there is no text information being broadcast.  Turn Off in the 

 

  CAPTIONS menu (page 37).

•  You cannot see a picture when you play a VCR tape. 

•  If you connected your VCR with A/V cables, use the INPUT 

 

 button to select the Input source (INPUT-1, INPUT-2, INPUT-3, 

 

 or INPUT-4) that the VCR is connected to.

 

•  Check your VCRs owner’s guide for further troubleshooting.

•  V-Chip Lock is not working 

•  Make sure that V-Chip is On (page 42).

 

•  If V-Chip Hours/Lock by Time is currently set to disable the 

 

  V-Chip lock, the V-Chip will not block programing.