Mitsubishi 2040u Manual De Usuario

- 12 -

Figure 10

(a) Disconnect and connect the USB cable to the up-

stream port of the display monitor.

(b) Cycle power of the display monitor off then on.

If the mark       appears with  “Generic USB HUB”, then
enumeration was unsuccessful.  Select “Generic USB
HUB” marked with      mark and click “Remove” and
“Refresh”.  After that, the enumeration is automatically
started.

The enumeration of USB HUB may be necessary for
each USB   port on the computer.

3.

Enumerate the Mitsubishi Monitor Function which
permits Monitor Control(height, width, rotation, etc) via
USB, using the following procedure.

(1) Insert Windows

®

 98 CD-ROM into your computer.

Then, Figure 11 will  appear.

Figure 11

Figure 8

The following procedure permits your computer to recog-
nize or "enumerate"(A USB term) the Mitsubishi USB HUB.

1.

Power on the display monitor and then the com-
puter.

2.

Start "Enumeration" from the Windows

®

 Desktop.

• During the enumeration of Mitsubishi USB Hub, connect

the keyboard and mouse, to the computer and not to the
downstream ports on the display monitor.  After the
enumeration, the keyboard and mouse can be used by
connecting to the downstream ports, if they are USB-
compliant.

• Do not unplug the USB cable during the enumerations.

(1) Connect the computer and the display monitor with an

USB cable.  Figure 8 will appear.

(2) Click “Next” on Figure 8 to get Figure 9.
(3) Click “Finish” on Figure 9 to complete the enumeration

of Mitsubishi USB HUB.

You can  confirm that “Mitsubishi USB HUB” is successfully
enumerated with the following method.

•

Open “Device Manager” tab in “System” property
under “Control Panel”.  Confirm that  “Generic USB
HUB” is listed in “Universal Serial Bus Controller”.  If
you can’t confirm it, re-enumerate “Mitsubishi USB
HUB” again by following (a) or (b).

Figure 9