Crown 1160ma Guía Del Usuario

2.7.5. Models CL1 & CL2 Stereo 
Mode

See Figure 2.14. In this example, Channel 1 and 
Channel 2 are wired to 4/8-ohm speaker loads.

Make sure the Mode switch is set to the “Stereo” 
position. 

INPUTS: Connect input wiring for each channel.

OUTPUTS:
• Connect Channel 1 positive (+) speaker lead 
to Channel 1 positive (+) terminal of amp. 
• Connect Channel 1 negative (–) speaker lead 
to Channel 1 negative (–) output terminal of 
amp.
• Repeat similarly for Channel 2.

Refer to Section 2.5 for output connector pin 
assignments.

See Figure 2.15. In this example, a 4/8-ohm load 
is connected in Bridge Mono across the positive 
terminals of Channel 1 and Channel 2. Make 
sure the Mode switch is set to the “Bridge” posi-
tion.

INPUTS: Connect input wiring to Channel 1.

OUTPUTS: Connect positive (+) speaker lead to 
Channel 1 positive (+) terminal of amp. Connect 
negative (–) speaker lead to Channel 2 positive 
(+) terminal of amp. Do not connect to negative 
output terminals.

Refer to Section 2.5 for output connector pin 
assignments.

Mixer

Mixer