Affirmative 7375 Guía Del Usuario
YEStablet 7375 User Guide—Operation Notes
OPERATION NOTES
Wireless Network Card and Antenna System
The 7375 has a PC Card slot along the upper left edge. This slot normally houses a wireless LAN adapter or Sierra
wireless cellular adapter. In certain configurations, the slot is left open for the user to insert a supported network
adapter. In the standard configuration, the 7375 is delivered with an embedded PC card 802.11b wireless LAN
adapter with a custom antenna in a snap-type housing. In this case, the user has the choice of leaving the antenna in
the snap-on position (A) or of pulling the antenna tip off the retainer snap and trying to obtain better wireless
connectivity through varying orientations up to near-vertical (B). Note: If the antenna is unsnapped, it becomes
vulnerable to damage. Any such damage is not covered by the tablet’s limited warranty.
(A)
(B)
Battery and Power Management
The 7375 is equipped with an internal Li-Ion battery pack that is capable of supporting approximately 2.5 hours of
continuous operation. The period of continuous operation can be extended to approximately 6 hours with the aid of
an optional external battery pack that clips onto the back of the tablet. The period between battery recharge can be
significantly lengthened by putting the tablet into Suspend mode through the Suspend button (see
) whenever the tablet is not in use. The 7375 may also be configured to automatically enter into power-saving
modes after user-definable periods of tablet idle – see Start > Settings > Control Panel > Power.
NOTE: Both the internal and external 7375 battery packs may be recharged with the accompanying AC-DC
adapter connected directly to the DC-in jack on the tablet or connected to the tablet Cradle. The external pack can
also be charged in the optional auxiliary battery charger cradle (see
NOTE: Both the internal and external 7375 battery packs may be recharged with the accompanying AC-DC
adapter connected directly to the DC-in jack on the tablet or connected to the tablet Cradle. The external pack can
also be charged in the optional auxiliary battery charger cradle (see
).
Power (Reset)/Suspend Button
The Power (Reset) and Suspend (Resume) button resides, slightly recessed, along the upper left edge of the 7375.
• Suspend/Resume
A brief push/release of the Suspend button toggles between Suspend and Resume – with adequate intervening
time. The system cannot enter into Suspend mode again within 15 seconds after Resuming.
time. The system cannot enter into Suspend mode again within 15 seconds after Resuming.
• COLD Boot/Power On-Off/Reset
You may use the Suspend button to Cold Boot or Restart the 7375 in the unlikely event of tablet lock-up. To
execute, push on the button for over 4 seconds to “Power Off” the tablet. The tablet will be turned off. This
Reset/Power Off will clear your firmware settings and data if they are not properly saved to flash memory (See
execute, push on the button for over 4 seconds to “Power Off” the tablet. The tablet will be turned off. This
Reset/Power Off will clear your firmware settings and data if they are not properly saved to flash memory (See
for reference). Push again on Suspend for a brief moment to restart/reboot the tablet.
17