Garmin 11 Manual De Propietario

T

ESTING

 

AND

 M

OUNTING

 

THE

 GTM 11

Use the following testing and troubleshooting techniques: 
Observe the LED on the GTM 11: Service reception is indicated by the 

green solid light, which can take up to five minutes to appear for initial 

data acquisition. 

   Yellow dot-dash flashes: determining which country 

you are currently in. 

   Yellow solid light: searching table for active entry or 

scanning for new TMC FM stations

   Red solid light: momentary sync loss.

  Green solid light: normal traffic data.

Check the Map: Check the map on the GPS device for traffic incidents. 

Refer to the owner’s manual to learn how to access the map page.
Verify Signal Strength: The traffic information list on the GPS device 

shows a signal strength indicator in the upper-right corner. Verify that the 

bars are solid green. Refer to the owner’s manual to learn how to access 

the information list.
Verify that you are in a service area: Check for service from the pay 

service or free services, if available. To view service areas, go to the 

Garmin Web site at http://www.garmin.com/fmtraffic.
Verify that the paid subscription is activated: If the GTM 11 is using a 

pay service, verify that the subscription has been activated in the Garmin 

GPS device. Refer to the GPS device’s owner’s manual

 to learn how to 

add subscriptions to the GPS device. 

After you have connected and tested the GTM 11, you can mount it using 

the hook-and-loop fastener or the permanent adhesive. For best signal 

reception, mount the GTM 11 on the A-pillar, which is the area between 

the windscreen and the door. If possible, mount the GTM 11 so you can 

see the LED. 
To mount the GTM 11 with the permanent adhesive:

1.  Clean and dry a section of the A-pillar or other suitable 

mounting surface. 

2.  Remove the backing from the adhesive. Firmly press the 

adhesive on the back of the GTM 11. 

3.  Position so the antenna is pointing up. 
4.  Remove the backing from the adhesive.
5.  Firmly press the GTM 11 to the mounting surface.

  NOTE: When mounted, the adhesive is extremely difficult to remove.