KitchenAid KBLO36FTX Guía Del Usuario

Descargar
Página de 52
8
Top Grille Temperature Display (Pro Line™ Models Only)
The top grille temperature display shows the freezer and 
refrigerator temperatures. The display will show either Fahrenheit 
or Celsius, depending on the selected reading inside the 
refrigerator.
During the defrost cycle, the temperature display will show the 
temperature set points.
Water Filtration System
The Base Grille Water Filter Status Light 
The water filter indicator display or light will help you know when 
to change your water filter cartridge. The display or light is 
located at the top of the refrigerator compartment. 
NOTE: Do not use with water that is microbiologically unsafe 
or of unknown quality without adequate disinfection before 
or after the system.  Systems certified for cyst reduction may 
be used on disinfected waters that may contain filterable 
cysts.
A new water filter should display a reading of 99% and will 
continue to decrease as the filter life is used. When display reads 
10%, it is time to order a replacement filter. It is recommended 
that you replace the base grille water filter cartridge when the 
water filter indicator light changes to 0% OR when water flow to 
your water dispenser or ice maker decreases noticeably. (See 
“Changing the Base Grille Filter” later in this section.)
After changing the water filter cartridge, reset the water filter 
status light by pressing and holding the RESET for 2 seconds. 
The indicator light will change to 99% when the filter indicator is 
reset.
Changing the Base Grille Filter
1. Locate the water filter cartridge cap in the front base grille. 
Rotate the cap counterclockwise to a vertical position and 
pull the cap and filter cartridge out through the base grille.
NOTE: There will be water in the cartridge. Some spilling may 
occur. 
2. Remove the cartridge cap by sliding it off the end of the old 
cartridge. The cap will slide to the left or right.
IMPORTANT: Do not discard the cap. It is part of your 
refrigerator. Keep the cap to use with the replacement filter.  
3. Take the new cartridge out of its packaging and remove 
protective cover from o-rings.
4. Slide the cartridge cap onto the new cartridge. See 
illustration in Step 2.
5. With cartridge cap in the vertical position, push the new filter 
cartridge into the base grille until it stops. Rotate the cartridge 
cap clockwise to a horizontal position. Discard the first three 
batches of ice produced after replacing the filter. 
Using the Ice Maker Without the Water Filter
You can run the ice maker without a water filter cartridge. Your ice 
will not be filtered.
1. Remove the base grille water filter cartridge. 
2. Slide the cartridge cap off the end of the filter cartridge. With 
the cartridge cap in the vertical position, insert the cap into 
the base grille until it stops.
IMPORTANT: Do not discard the cap. It is part of your 
refrigerator. Keep the cap to use with the replacement filter.  
3. Rotate the cartridge cap to a horizontal position. The 
cartridge cap might not be even with the base grille.
A. Freezer temperature display
B. Refrigerator temperature display
B
A