KitchenAid koru06rsss Manual De Usuario

NOTE: Before performing any type of installation, cleaning, or 
removing a light bulb, turn the control to the Off position as 
shown and then disconnect the refrigerator from the electrical 
source.

When you are finished, reconnect the refrigerator to the electrical 
source and reset the control to the desired setting. See “Using 
the Control.”

■

Using a T–16 torque wrench, remove skids from the bottom 
of the refrigerator and properly discard the attachment bolts.

■

Remove tape and glue residue from surfaces before turning 
on the refrigerator. Rub a small amount of liquid dish soap 
over the adhesive with your fingers. Wipe with warm water 
and dry.

■

Do not use sharp instruments, rubbing alcohol, flammable 
fluids, or abrasive cleaners to remove tape or glue. These 
products can damage the surface of your refrigerator. For 
more information, see the “Refrigerator Safety” section.

■

Dispose of all packaging materials properly.

After you remove all of the packaging materials, clean the inside 
of your refrigerator before using it. See the cleaning instructions 
in the “Refrigerator Care” section.

■

Always lay the refrigerator with the hinge facing upward 
during the leveling leg installation. If you lay the refrigerator 
on its back, you can damage the refrigerator.

■

Do not place refrigerator on its top. It may damage the 
compressor.

■

Allow the refrigerator to sit upright for 4 hours before plugging 
into an electrical outlet.

1. Using two or more people, lay the refrigerator on its side. 

2. Screw two leveling legs into the bottom of the refrigerator at 

the front.

3. Screw two leveling legs into the bottom of the refrigerator at 

the rear.

4. Using two or more people, stand the refrigerator upright.

5. Allow the refrigerator to sit upright for 4 hours.

IMPORTANT: To prevent floor damage, keep the cardboard 
shipping piece or plywood under the refrigerator until it is 
installed in the operating position.

6. Move the refrigerator to its final location. Be sure to move the 

refrigerator straight back and evenly into the opening.

7. Lower the front legs just enough to lift the cabinet up off of 

the floor.

8. Adjust the legs to level the refrigerator:

■

Turn the leveling leg to the right (clockwise) to lower that 
side of the refrigerator.

■

Turn the leveling leg to the left (counterclockwise) to raise 
that side of the refrigerator.

Your refrigerator is heavy. When moving the refrigerator 
for cleaning or service, be sure to protect the floor. 
Always pull the refrigerator straight out when moving it. 
Do not wiggle or “walk” the refrigerator when trying to move 
it, as floor damage could occur.