Lexmark c912 Instruccion De Instalación
Step 5: Install memory and
option cards
CAUTION:
If you are installing memory or option cards
after initial printer setup, turn the printer off and unplug the
power cord. If you have any other devices connected to
the printer, turn them off as well and unplug any cables
going to the printer.
power cord. If you have any other devices connected to
the printer, turn them off as well and unplug any cables
going to the printer.
Removing the system board access
cover
cover
Rear cover
If you did not purchase any memory,
firmware, or option cards, skip this step
and go to “Step 6: Load paper” on
page 38.
firmware, or option cards, skip this step
and go to “Step 6: Load paper” on
page 38.
You can customize your printer memory
capacity and connectivity by adding
option cards or a hard disk.
capacity and connectivity by adding
option cards or a hard disk.
You must remove the system board cover
to install memory cards, a firmware card,
a hard disk, or an option card.
to install memory cards, a firmware card,
a hard disk, or an option card.
You need a number 2 Phillips screwdriver
to remove the system board cover.
to remove the system board cover.
Install memory and option cards
29