Citel 6000 Guía De Instalación

EXTender 6000 Quick Installation Guide

 

7

 

 

Prerequisites for Installation 

You must meet the following requirements before installing the EXTender 6000: 

•  You must install and configure appropriate network terminating devices at both the corporate facility 

and the branch office. Both network-terminating devices must be fully functional and both must 
support an RS-232, V.35, or RS-530 synchronous, asynchronous or Voice over IP (VOIP) interface. 

•  If you use an asynchronous connection, you must install the appropriate ISDN Terminal Adapters 

(TAs), from the list below. The TAs must be operational at both the corporate facility and the Branch 
Office. This list is complete as of the release date of this document. Refer to the MCK’s Web site: 

 for the most recent list of recommended ISDN TAs.  If using a synchronous 

connection please see page 19 for more information. 

3Com 3Com 

U.S. 

Robotics 

Adtran ISU 

2X64 

ISU 128 
Express NTU 
Express 3000 

Motorola 

Bitsurfr Pro (rev 1M) 
Bitsurfr Pro EZ 
Bitsurfr Pro for Europe 

-- <MANUAL_SETUP_1> 

<MANUAL_SETUP_2> 

* Connect 

IQ 400 Series 

* Multitech 

IWAY Hopper (Async only) 

 
 * European Use 
 
Note: For the Async-RS 232 Dial feature to work properly for these devices, you must set up each device 

 
Provide proper wiring with adequate punchdown blocks to connect the Remote Unit to the telephones. 
Follow the details in Pin Out Assignments on page 14, and provide an RJ-21 female connector.