Citel 6000 Guía Del Usuario
PBXgateway
™
& EXTender
TM
6000 System Administrator’s Guide
99
Enabling ConneX
The PBXgateway supports the ConneX features. This application puts PBX features and dialtone
in the hands of users of remote telephones. For instructions on setting up your ConneX phone
please see Appendix F: ConneX Application Guide starting on page 250.
Note: If ADSI (Analog Display Service Interface) enabled phones are being used the user will
have access to all the RemoteConneX features. If Analog or mobile phones are being used by a
remote worker the MobileConneX features will be accessible to the user. The prompts for this
application are very similar but may differ in some instances.
The PBXgateway is an application-specific gateway capable of extending dialtone and features of
the enterprise PBX to up to 12 users of ConneX Phones and/or mobile phones. ConneX features
can be enabled on a port-by-port basis.
Note: Setting the ConneX port values in the default port menu will assign these values, and the
associated ConneX features to all ports. If you wish to use a single port for ConneX then
configure an individual port.
Note: Norstar Only – Set the Handsfree menu item, on the KSU, to None.
DN for Connex_Link = Handsfree = None
DN for Voice = Handsfree = None
Procedure (Gateway Only)
1. (Norstar Only) Access the Port menu and set the CH1 Usage to ConneX_Link. Set this for
in the hands of users of remote telephones. For instructions on setting up your ConneX phone
please see Appendix F: ConneX Application Guide starting on page 250.
Note: If ADSI (Analog Display Service Interface) enabled phones are being used the user will
have access to all the RemoteConneX features. If Analog or mobile phones are being used by a
remote worker the MobileConneX features will be accessible to the user. The prompts for this
application are very similar but may differ in some instances.
The PBXgateway is an application-specific gateway capable of extending dialtone and features of
the enterprise PBX to up to 12 users of ConneX Phones and/or mobile phones. ConneX features
can be enabled on a port-by-port basis.
Note: Setting the ConneX port values in the default port menu will assign these values, and the
associated ConneX features to all ports. If you wish to use a single port for ConneX then
configure an individual port.
Note: Norstar Only – Set the Handsfree menu item, on the KSU, to None.
DN for Connex_Link = Handsfree = None
DN for Voice = Handsfree = None
Procedure (Gateway Only)
1. (Norstar Only) Access the Port menu and set the CH1 Usage to ConneX_Link. Set this for
the ports that you will be using for ConneX users only. Do not set this in the Default port
menu.
menu.
2. (Meridian and Avaya) Access the Port menu and set the CH2 Usage to ConneX_Link. Set
this for the ports that you will be using for ConneX users only. Do not set this in the Default
port menu.
port menu.
3. (Norstar Only) Create the ConneX Link and Voice on the same DSP. For example select
Port_1 and set the Ch1 Usage to ConneX_Link. Access Port_2 and set the CH1 Usage to
Voice. You can use any two ports in sequential pairs starting at Port_1. So you can use
Port_1 and 2, Port_3 and 4, Port_5 and 6 etc.
Voice. You can use any two ports in sequential pairs starting at Port_1. So you can use
Port_1 and 2, Port_3 and 4, Port_5 and 6 etc.