Citel 6000 Guía Del Usuario
PBXgateway
™
& EXTender
TM
6000 System Administrator’s Guide
153
System Status LEDs
The PBXgateway and Branch Office units have four tri-color LEDs – (RED, Yellow, and
Green) indicating the unit status once the runtime image is operating and the status condition
of the WAN ports has been determined.
IMPORTANT: Refer to page 156 for troubleshooting the units using the System Status LEDs.
Green) indicating the unit status once the runtime image is operating and the status condition
of the WAN ports has been determined.
IMPORTANT: Refer to page 156 for troubleshooting the units using the System Status LEDs.
LED States
LED LABEL
Off
Solid Red
Solid
Yellow
Flashing
Yellow
Solid
Green
Slow
Green
Flash
Fast
Green
Flash
PWR Off
DRAM
Test
failed
Test
failed
Self-test
Diagnostic
Error
Diagnostic
Error
-
Has
power
power
-
-
WAN1 Not
enabled
No Device
connected
connected
DCE
Ready
Ready
DCE
Ready
Ready
Carrier
Up
Up
Remote
Up
Up
Remote
test
test
WAN2 Not
enabled
No Device
connected
connected
DCE
Ready
Ready
-
Carrier
Up
Up
Remote
Up
Up
Remote
test
test
WAN3
Not
enabled
enabled
No Device
connected
connected
DCE
Ready
Ready
Carrier
UP
UP
In Use
Remote
test
test
*Analog -
- Card
detected
and
Onhook
and
Onhook
Ringing
Onhook
on
analog
call.
on
analog
call.
-
-
* Applies to EXTender 6000 equipped with an Analog Port only.
Table 16: WAN and Power Status LEDs
DRAM Test Failed: This indicates that one or all of the four DRAM tests have failed. This hardware
failure condition can be caused by a faulty internal DRAM chip. Recycle the power on the unit and contact
MCK if the light remains “Red”.
Selftest Diagnostic Error: This indicates that there is a problem with a selftest, indicating a possible
hardware problem. Recycle the power on the unit and contact Customer Support if the light remains
“Yellow”.
Not Enabled: Enable the WAN port, if the WAN port is needed.
Table 16: WAN and Power Status LEDs
DRAM Test Failed: This indicates that one or all of the four DRAM tests have failed. This hardware
failure condition can be caused by a faulty internal DRAM chip. Recycle the power on the unit and contact
MCK if the light remains “Red”.
Selftest Diagnostic Error: This indicates that there is a problem with a selftest, indicating a possible
hardware problem. Recycle the power on the unit and contact Customer Support if the light remains
“Yellow”.
Not Enabled: Enable the WAN port, if the WAN port is needed.
No Device Connected:
Check the wiring and cable pinouts between both units and the network device. (see page 37 for pinout
information)
Check the cable.
DCE Ready: Device connected but no network link to the alternate site. Possibly a network error between
devices. Check all cables and power to the units.
Carrier Up: Network link established. Try to establish phone connection from the Remote unit.
Check the wiring and cable pinouts between both units and the network device. (see page 37 for pinout
information)
Check the cable.
DCE Ready: Device connected but no network link to the alternate site. Possibly a network error between
devices. Check all cables and power to the units.
Carrier Up: Network link established. Try to establish phone connection from the Remote unit.