Citel 6000 Guía Del Usuario
PBXgateway
™
& EXTender
TM
6000 System Administrator’s Guide
174
Configuration File Management
Changing the Active Config file
Introduction
When the PBXgateway is powered-up, the Flash file system loads a
configuration file (called the “active” .rem (Remote) or .swt (Switch) file) which
contains all the parameters necessary for operation. The system administrator
can change this “active” .rem (Remote) or .swt (Switch) file so that a different
set of parameters loads.
Note: The default configuration file shipped with the units is runtime.rem or
runtime.swt.
configuration file (called the “active” .rem (Remote) or .swt (Switch) file) which
contains all the parameters necessary for operation. The system administrator
can change this “active” .rem (Remote) or .swt (Switch) file so that a different
set of parameters loads.
Note: The default configuration file shipped with the units is runtime.rem or
runtime.swt.
Procedure
Access the Config Menu using the following path:
Path: Utilities->Upgrade->Config File
Select an existing .rem (Remote) or .swt (Switch) file from the list displayed.
The display reads;
Change Configuration file to……
Enter (Y) or (N).
The unit will then prompt you to reboot. This change requires a reboot in order
to take affect.
All changes made to the Switch or Remote parameters will be saved under the
new config file.
Path: Utilities->Upgrade->Config File
Select an existing .rem (Remote) or .swt (Switch) file from the list displayed.
The display reads;
Change Configuration file to……
Enter (Y) or (N).
The unit will then prompt you to reboot. This change requires a reboot in order
to take affect.
All changes made to the Switch or Remote parameters will be saved under the
new config file.