Citel 6000 Guía Del Usuario
PBXgateway
™
& EXTender
TM
6000 System Administrator’s Guide
39
Compatible Remote Units
The PBXgateway is compatible with the following Remote units:
EXTender 6000 – for Branch Offices.
Provides connectivity for up to 12 remote users from a single branch office location. Each
phone is cross-wired to a port on the unit.
EXTender 4000 – for IP
Provides connectivity for a single user client via an IP network. The single user phone is simply
plugged into the Remote unit “phone” port.
EXTender 6000 – for Branch Offices.
Provides connectivity for up to 12 remote users from a single branch office location. Each
phone is cross-wired to a port on the unit.
EXTender 4000 – for IP
Provides connectivity for a single user client via an IP network. The single user phone is simply
plugged into the Remote unit “phone” port.
Connecting the Remote Unit to the User phones
Required
Components
Procedure
Components
Procedure
• One RJ-21 cable with 50-pin female connector.
• Active network from the Branch Office to the corporate facility over
• Active network from the Branch Office to the corporate facility over
an ISDN or IP.
• Installed network device.
• Digital phone(s) and line cord(s)
• Cross-connection wiring block or break-out box sufficient for the
• Digital phone(s) and line cord(s)
• Cross-connection wiring block or break-out box sufficient for the
installation
• Additional RJ-11 or RJ-45 phone cords.
Note: For detailed wiring information please refer to page 39.
1.
Install (2) cross-connect wiring block or use a single breakout box.
2.
Connect the Remote phones to a punch block or breakout box.
3.
Wire breakout box or punch block to 50-pin cable RJ-21 connector.
4.
Connect the 50-pin, RJ-21 cable to telephony interface at the
Remote unit.
Remote unit.
IMPORTANT: DO NOT connect the Remote Unit to a PBX/KSU.