Citel 6000 Guía Del Usuario
PBXgateway
™
& EXTender
TM
6000 System Administrator’s Guide
57
Asynchronous-Serial Device Configuration (RVP_Direct)
This section of the manual provides the necessary information to configure the PBXgateway
™ for
connection to an asynchronous-serial device. The units are programmed at the factory with “default”
settings providing basic parameters to accommodate many network environments.
settings providing basic parameters to accommodate many network environments.
Prerequisites for Configuration
The PBXgateway (at the corporate site) and the EXTender 6000 (at the branch office) must be installed
properly and the network link between both devices must be operational.
Basic Configuration - EXTender and PBXgateway
properly and the network link between both devices must be operational.
Basic Configuration - EXTender and PBXgateway
You must ….……
to…………
Default Setting Refer to
page..
Enable the WAN port and set
the mode (interface type).
the mode (interface type).
Match the interface type of
the network device.
the network device.
Set the Async parameters for
the selected WAN port.
the selected WAN port.
Match the settings for the
device being used.
device being used.
Set the “Jitter” and
“Compression” settings.
“Compression” settings.
Match the available
bandwidth and quality.
bandwidth and quality.
Jitter: 5
Compression
: ADPCM32
Compression
: ADPCM32
Table 9:
Configuration Steps