Citel 6000 Guía Del Usuario

 

PBXgateway

™ 

& EXTender

TM

 

6000 System Administrator’s Guide

 

61

 

 
IMPORTANT: Changes made in this section, via the MI, are saved to the “Active” config file 
stored on the Gateway and EXTender unit. All configuration files are saved with a .rem extension 
for Remote unit files, and a .swt extension for PBXgateway files. The MI will prompt you to save 
changes as necessary. There are options for saving these parameters under a different file name, 
or creating and editing a “non-active” configuration file. (see page 175, for more information)  
 
IMPORTANT INFORMATION 
 
Initial MI Connection 
The initial set up of the PBXgateway MUST be done through a direct serial connection (see page 
44), until the IP parameters have been entered (see page 76) allowing configuration via Telnet 
through the Ethernet port. 
 
Default Settings 
The units are programmed at the factory with “default” settings providing basic parameters to 
accommodate many network environments. It may be necessary to change these settings 
depending on the network. 
 
Set up Wizard 
This is a setup program accessed through a direct-serial connection.  The wizard prompts you to 
enter required information necessary for configuring the PBXgateway. (see page 104, for more 
information) 
 
Multiple Remotes (RVP_Over_IP only) 
The PBXgateway can interface with multiple clients from one to twelve users. It is necessary to 
know the type of Remote units that are communicating with the PBXgateway for proper 
configuration.