Citel 6000 Guía Del Usuario
PBXgateway
™
& EXTender
TM
6000 System Administrator’s Guide
88
Optional PBXgateway Parameters
The following pages describe helpful but optional parameters. Refer to these parameters when needed.
2:1 Configuration
Included in this release is the ability to connect two EXTender 6000 remote units, using RVP_Direct to the
two WAN ports of the PBXgateway.
two WAN ports of the PBXgateway.
Typical Installation
The first EXTender 6000 is connected to WAN1 of the PBXgateway. The second EXTender 6000 is
connected to WAN2 of the PBXgateway. This must be the configuration; otherwise warning log messages
will be logged.
Configuring the Gateway and Remote
1. In the “RVP_Direct” menu, set the Number of Remotes to [2].
connected to WAN2 of the PBXgateway. This must be the configuration; otherwise warning log messages
will be logged.
Configuring the Gateway and Remote
1. In the “RVP_Direct” menu, set the Number of Remotes to [2].
Figure 42: Number of Remote in 2:1
2. In the “WAN 2” menu, enable WAN 2.
3. Set the WAN Mode. See page 70.
4. Set the Sync Setup parameters. See page 71.
3. Set the WAN Mode. See page 70.
4. Set the Sync Setup parameters. See page 71.
Figure 43: Enabling WAN
3. Reboot the PBXgateway.
IMPORTANT: You cannot “Rlogin” to either remote unit until each remote has at least one phone
connected. And WAN stats shows Active.
IMPORTANT: You cannot “Rlogin” to either remote unit until each remote has at least one phone
connected. And WAN stats shows Active.